Dây chuyền sản xuất cáp GYXTC8S

The reference construction uses colored optical fibers inside jelly-filled PBT loose tubes, SZ stranded around the specified central strength member with fillers and water blocking. The core is then protected by corrugated steel tape and completed with a messenger wire inside the figure-8 PE sheath. Fiber count, dimensions and material grades follow the approved cable drawing.

Not always. If qualified colored fibers are supplied in the required package and are ready for loose-tube production, the reviewed project scope may begin at HK-50. If coloring, rewinding or package preparation is required, the HK-235 reference stage must be evaluated with the fiber input specification.

HK-235 prepares the fibers, HK-50 forms the jelly-filled PBT loose tubes, HK-800/12 SZ builds the cable core, and HK-90 forms the corrugated steel-tape armor before messenger positioning and figure-8 PE sheathing. The four stages keep each material handoff visible while preserving one connected GYXTC8S production route.

No. They are reference production-stage models used to explain the process route. Final module quantities, dimensions, controls, utilities, optional systems and equipment interfaces are confirmed only after reviewing the cable drawing, materials, capacity target and factory conditions.

Potentially, subject to technical review. HONGKAI must confirm material package sizes, tension ranges, line interfaces, control signals, dimensions, utilities, operating conditions and required tests before existing equipment or buyer-supplied materials are included in the proposed route.

Please provide the cable drawing or specification, fiber count, finished diameter, required materials, product mix, target output, expected operating speed, reel sizes, shift pattern, available utilities, factory layout and project schedule. This reference page does not assume a standard project capacity.

No. The images illustrate the HK-235, HK-50, HK-800/12 SZ and HK-90 reference stages. The related video demonstrates the SZ stranding process only. It does not represent the complete four-stage project route, the final equipment arrangement, a production result or an acceptance record.

Inspection points, FAT requirements, acceptance criteria, documentation, installation, commissioning, training, travel and on-site responsibility are project-scope items. Their exact content must be defined in the technical proposal and mutually approved commercial agreement.